User Manual
Table Of Contents
- Contents
- Introduction
- Safety information
- Features
- Preparing to assemble your desk
- Assembling your desk
- STEP 1: Insert wooden dowels into the hutch divider panels
- STEP 2: Insert wooden dowels into the bottom hutch panel
- STEP 3: Connect the hutch divider panels to the bottom hutch panel
- STEP 4: Insert wooden dowels into the back hutch panel
- STEP 5: Connect the back hutch panel to the hutch assembly
- STEP 6: Insert wooden dowels and cam-lock screws into the left and right hutch panels
- STEP 7: Connect the left and right hutch panels to the hutch assembly
- STEP 8: Insert cam-lock screws into the top hutch panel
- STEP 9: Connect the top hutch panel to the hutch assembly
- STEP 10: Connect the hutch assembly to the main desktop
- STEP 11: Attach support bars to the side leg assembly
- STEP 12: Attach the center leg to the side leg assembly supports
- STEP 13: Attach support bars to the main leg assembly
- STEP 14: Connect the main leg assembly and side leg assembly
- STEP 15: Secure the main leg assembly and side leg assembly
- STEP 16: Attach the desktops to the leg assembly
- STEP 17: Attach the cross bars to your desk
- STEP 18: Secure your desk to the wall
- Cleaning your desk
- Specifications
- Troubleshooting
- ONE-YEAR LIMITED WARRANTY
5
L-Shaped Computer Desk
www.insigniaproducts.com
Hardware included
Tools needed
Preparing to assemble your desk
1 Follow the assembly instructions carefully.
2 Make sure that all parts and hardware are included.
3 To prevent product damage, assemble your desk on top of the box.
4 Have another person help you with lifting and assembly.
5 For the best results, do not fully tighten the screws until you have assembled all the other parts.
CAUTION: Do not use a drill to assemble your desk. The drill should only be used to secure your desk to the wall (step 18).
LABEL HARDWARE QTY.
A26
B19
C19
D3
E13
F13
G16
Wooden dowels
Cam-lock
screws
Cam locks
3.8 × 45 mm
screws
M6 × 30 mm
bolts
Washers
Screw covers
LABEL HARDWARE QTY.
H2
I8
J10
K6
L7
M1
Anchors
M5 × 15 mm
bolts
M6 × 15 mm
bolts
5 × 50 mm
screws
M6 × 50 mm
bolts
Hex wrench
Drill with M8 bit
(For wall mounting only)HammerPhillips #2 screwdriver Pencil