User Manual
Table Of Contents
- Contents
- Introduction
- Safety information
- Features
- Preparing to assemble your desk
- Assembling your desk
- STEP 1: Insert wooden dowels into the hutch divider panels
- STEP 2: Insert wooden dowels into the bottom hutch panel
- STEP 3: Connect the hutch divider panels to the bottom hutch panel
- STEP 4: Insert wooden dowels into the back hutch panel
- STEP 5: Connect the back hutch panel to the hutch assembly
- STEP 6: Insert wooden dowels and cam-lock screws into the left and right hutch panels
- STEP 7: Connect the left and right hutch panels to the hutch assembly
- STEP 8: Insert cam-lock screws into the top hutch panel
- STEP 9: Connect the top hutch panel to the hutch assembly
- STEP 10: Connect the hutch assembly to the main desktop
- STEP 11: Attach support bars to the side leg assembly
- STEP 12: Attach the center leg to the side leg assembly supports
- STEP 13: Attach support bars to the main leg assembly
- STEP 14: Connect the main leg assembly and side leg assembly
- STEP 15: Secure the main leg assembly and side leg assembly
- STEP 16: Attach the desktops to the leg assembly
- STEP 17: Attach the cross bars to your desk
- STEP 18: Secure your desk to the wall
- Cleaning your desk
- Specifications
- Troubleshooting
- ONE-YEAR LIMITED WARRANTY
17
L-Shaped Computer Desk
www.insigniaproducts.com
STEP 11: Attach support bars to the side leg assembly
You n e ed:
1 Align the side front support bar (15) with the top/front hole in the side leg assembly (10), then secure with a M6 ×
50 mm bolt (L) and a hex wrench (M). Make sure that the holes in the side front support bar (15) face the front and
back of your desk (as shown).
2 Align the side back support bar (14) with the top/back hole in the side leg assembly (10), then secure with a M6 ×
50 mm bolt (L) and a hex wrench (M). Make sure that the outermost holes in the side back support bar (14) face the
back of your desk (as shown).
3 Align the bottom support bar (13) with the bottom/back bracket in the side leg assembly (10), then secure with
two M6 × 15 mm bolts (J) and a hex wrench (M). Make sure that the holes in the bottom support bar (13) face the
back of your desk (as shown).
Note: To make assembly easier, do not lock the bolts tightly until you have assembled all other parts.
J
M6 × 15 mm bolts (2)
M
Hex wrench
L
M6 × 50 mm bolts (2)
10
Side leg assembly
13
Bottom support bar (1)
14
Side back support bar
15
Side front support bar
TOP/FRONT
BOTTOM/BACK