User Manual
Table Of Contents
- Safety information and specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud* wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Install the decorative end caps
- STEP 7 - Mount the TV to the wall plate
- STEP 8 - Manage cables
- STEP 9 - Adjust the mount angle
- STEP 10 - Secure the TV to the wall plate
- ONE-YEAR LIMITED WARRANTY
7
www.insigniaproducts.com
Full Motion Mount for TVs 47" - 90"
STEP 3 - Option 1: Attaching the mounting hardware to TVs
with a flat back
1 Align the left and right TV brackets with the screw holes on the back of the TV. Make sure that the
brackets are level.
2 Install washers (A11 or A12), and screws (A1, A3, A5, or A7) into the holes in the back of the TV.
3 Tighten the screws until they are snug against the TV brackets. Do not over tighten.
You’ll need
A11
or A12
A1/A3
or A5/A7
Wall brackets
A7 (4)A1 (4)
Phillips screwdriver
Screws
Washers
TV brackets
(2)
or
A3 (4)
A11 (4)
A5 (4)
Magnetic
removable bubble
level
oror
A12 (4)
or