User Manual
Table Of Contents
- Safety information and specifications
- Tools needed
- Package contents
- Installation instructions
- STEP 1 - Determine whether your TV has a flat back or an irregular or obstructed back
- STEP 2 - Select screws, washers, and spacers
- STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back
- STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs
- STEP 4 - Determine wall-mount location
- STEP 5 - Option 1: Installing on a wood stud* wall
- STEP 5 - Option 2: Installing on a solid concrete or concrete block wall
- STEP 6 - Install the decorative end caps
- STEP 7 - Mount the TV to the wall plate
- STEP 8 - Manage cables
- STEP 9 - Adjust the mount angle
- STEP 10 - Secure the TV to the wall plate
- ONE-YEAR LIMITED WARRANTY
15
www.insigniaproducts.com
Full Motion Mount for TVs 47" - 90"
STEP 9 - Adjust the mount angle
1 To adjust the arm tension (to make the arm easier or harder to move), loosen or tighten the tension
screw with an Allen wrench.
2 To rotate the TV left or right, hold the sides of the TV, then push one side while pulling the other side.
3 To tilt of the TV up or down, hold the top and bottom of the TV, then tilt the TV forward or backward.
You’ll need
Tension
screw
Allen
wrench
± 90°
± 180°
-2° ~ 10°
±
3
°
Allen wrench