User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Assembling your stand
- STEP 1: Attach the top panel to the spine
- STEP 2: Attach the top shelf support to the top panel and spine
- STEP 3: Attach the middle shelf to the spine
- STEP 4: Attach the bottom shelf to the spine
- STEP 5: Align and attach the right side frame to the shelves
- STEP 6: Attach the right side frame to the top panel
- STEP 7: Attach the left side frame to the shelves
- STEP 8: Fasten the left side frame to the top panel
- Mounting the TV using the swivel configuration
- STEP 1: Attach the swivel bracket to the mounting frame
- STEP 2: Attach the swivel bracket assembly to the spine
- STEP 3: Attach the cable clips
- STEP 4: Select the correct bolts, washers, and spacers for your TV
- STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
- STEP 6: Option 1 - Mounting brackets on a TV with a flat back
- STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
- STEP 7: Attach the TV to the mounting frame on the swivel bracket
- STEP 8: Adjusting the tilt
- STEP 9: Position your TV stand and install the tipping restraint hardware kit
- Mounting the TV using the wall-mount configuration
- Mounting the TV using the tabletop configuration
- Maintaining your TV stand
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
8
Assembling your stand
STEP 1: Attach the top panel to the spine
You need:
1 Align the top shelf frame (A) at a 90° angle to the spine assembly (F). Make sure that the drilled holes on the frame align
with the threaded holes on the spine.
2 Insert two 1 3/4" bolts (P) through the drilled holes on the frame (A), then screw them into the holes on the spine
assembly with the 4 mm hex key (W).
Tip: Assemble your stand on a carpeted floor or the empty TV stand carton to avoid scratching it.
Note: Do not fully tighten all bolts until you finish assembling all of the parts. After assembly, go back and fully
tighten all bolts. This will make the assembly easier.
Note: The metal frame faces the floor when you turn your stand upright.
Note: Do not fully tighten all bolts until you finish assembling all of the parts. After assembly, go back and fully
tighten all bolts. This will make the assembly easier.
A Top shelf frame (1)
F Spine assembly (1)
P Bolt 1 3/4" (2)
W 4 mm hex key (1)
Metal frame