User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Assembling your stand
- STEP 1: Attach the top panel to the spine
- STEP 2: Attach the top shelf support to the top panel and spine
- STEP 3: Attach the middle shelf to the spine
- STEP 4: Attach the bottom shelf to the spine
- STEP 5: Align and attach the right side frame to the shelves
- STEP 6: Attach the right side frame to the top panel
- STEP 7: Attach the left side frame to the shelves
- STEP 8: Fasten the left side frame to the top panel
- Mounting the TV using the swivel configuration
- STEP 1: Attach the swivel bracket to the mounting frame
- STEP 2: Attach the swivel bracket assembly to the spine
- STEP 3: Attach the cable clips
- STEP 4: Select the correct bolts, washers, and spacers for your TV
- STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
- STEP 6: Option 1 - Mounting brackets on a TV with a flat back
- STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
- STEP 7: Attach the TV to the mounting frame on the swivel bracket
- STEP 8: Adjusting the tilt
- STEP 9: Position your TV stand and install the tipping restraint hardware kit
- Mounting the TV using the wall-mount configuration
- Mounting the TV using the tabletop configuration
- Maintaining your TV stand
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
31
3-in-1 TV Stand
STEP 5: Attach the TV to the mounting frame on the wall
You need:
1 Depending on the type of TV that you own, attach the TV brackets (J) to the back of the TV following the steps in:
• STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
on page 20
• STEP 6: Option 1 - Mounting brackets on a TV with a flat back on page 21
• STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
on
page 22
.
2 With the help of another adult, lift the TV up to the mounting frame (I).
3 Set the hooks on TV brackets (J) over the mounting frame, then lower the hooks onto the bars on the mounting frame.
4 Center the TV, then secure it in place using a Phillips screwdriver to tighten the safety bolt on the bottom hooks.
Tighten until the safety bolt hits the underside of the mounting frame.
5 Place your stand with the shelves under the TV.
6 Position your assembled stand against a wall where you plan to use it.
7 Adjust the leveling feet to level your TV stand.
8 Follow the instructions printed on the bag containing the tipping restraint hardware kit (Z) to attach the restraint
hardware to the wall and your stand.
WARNING: The tipping restraint must be installed correctly. Failure to do this could result in your TV/stand assembly falling
forward, resulting in damage to equipment or personal injury.
Phillips screwdriver
Note: In this step the mounting
frame has already been mounted to
the wall. This illustration shows the
TV from the back view for clarity.
Safety
bolt