User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Assembling your stand
- STEP 1: Attach the top panel to the spine
- STEP 2: Attach the top shelf support to the top panel and spine
- STEP 3: Attach the middle shelf to the spine
- STEP 4: Attach the bottom shelf to the spine
- STEP 5: Align and attach the right side frame to the shelves
- STEP 6: Attach the right side frame to the top panel
- STEP 7: Attach the left side frame to the shelves
- STEP 8: Fasten the left side frame to the top panel
- Mounting the TV using the swivel configuration
- STEP 1: Attach the swivel bracket to the mounting frame
- STEP 2: Attach the swivel bracket assembly to the spine
- STEP 3: Attach the cable clips
- STEP 4: Select the correct bolts, washers, and spacers for your TV
- STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
- STEP 6: Option 1 - Mounting brackets on a TV with a flat back
- STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
- STEP 7: Attach the TV to the mounting frame on the swivel bracket
- STEP 8: Adjusting the tilt
- STEP 9: Position your TV stand and install the tipping restraint hardware kit
- Mounting the TV using the wall-mount configuration
- Mounting the TV using the tabletop configuration
- Maintaining your TV stand
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
30
STEP 4: Option 2- Mount the frame to a block or concrete wall
You need:
1 Place the mounting frame (I) against the wall where you intend to mount the TV. Use a level to make sure that the
mounting frame is level, then mark the four mounting holes on the wall. Remove the mounting frame.
2 Drill four 7/16" (11 mm) holes through the screw marks to a depth of 2.5" (64 mm) using a drill with a 7/16" masonry
drill bit.
3 Insert a concrete anchor (T) into each of the screw holes using a hammer.
4 Align the mounting frame over the concrete anchors.
5 Place a washer (U) over one of the mounting frame screw holes, then insert a lag bolt (S) and tighten.
6 Repeat the previous step for the other three screw holes.
CAUTION: Never locate the mounting holes into the mortar between blocks. The TV may fall causing damage or
injury.
CAUTION: Make sure that the lag bolts are tight and secure, but do not overtighten them.
Power drill
Edge-to-edge
stud finder
Hammer
Pencil
Level
Socket wrench
7/16” masonry drill bit
S Lag bolt (4)
U Large flat washer (4)
T Concrete anchor (4)
2.5"
(64 mm)
(11 mm)
.4"