User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Assembling your stand
- STEP 1: Attach the top panel to the spine
- STEP 2: Attach the top shelf support to the top panel and spine
- STEP 3: Attach the middle shelf to the spine
- STEP 4: Attach the bottom shelf to the spine
- STEP 5: Align and attach the right side frame to the shelves
- STEP 6: Attach the right side frame to the top panel
- STEP 7: Attach the left side frame to the shelves
- STEP 8: Fasten the left side frame to the top panel
- Mounting the TV using the swivel configuration
- STEP 1: Attach the swivel bracket to the mounting frame
- STEP 2: Attach the swivel bracket assembly to the spine
- STEP 3: Attach the cable clips
- STEP 4: Select the correct bolts, washers, and spacers for your TV
- STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
- STEP 6: Option 1 - Mounting brackets on a TV with a flat back
- STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
- STEP 7: Attach the TV to the mounting frame on the swivel bracket
- STEP 8: Adjusting the tilt
- STEP 9: Position your TV stand and install the tipping restraint hardware kit
- Mounting the TV using the wall-mount configuration
- Mounting the TV using the tabletop configuration
- Maintaining your TV stand
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
29
3-in-1 TV Stand
STEP 4: Option 1 - Mount the frame to a stud wall
If you are mounting the TV on a concrete or block wall, to go STEP 4: Option 2- Mount the frame to a block or concrete wall
on page 30.
You need:
1 Use a stud sensor to locate two adjacent wall studs, then position the mounting frame (I) exactly between the two
studs.
2 Use a level to make sure that the mounting frame is level, then mark the four mounting holes. Remove the mounting
frame.
3 Drill four 3/16" (4.8 mm) holes 2.5" (64 mm) deep using a drill with 3/16" a wood drill bit.
4 Align the mounting frame (I) with the pilot holes, then secure the frame to the wall with four lag bolts (S) and four
washers (U) using a socket wrench.
CAUTION: Make sure that the lag bolts are tight and secure, but do not overtighten them.
Power drill
Edge-to-edge stud finder
Hammer
Pencil
Level
Socket wrench
3/16" wood drill bit
S Lag bolt (4)
U Large flat washer (4)
2.5"
(64 mm)
.2"
(4.8 mm)