User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Assembling your stand
- STEP 1: Attach the top panel to the spine
- STEP 2: Attach the top shelf support to the top panel and spine
- STEP 3: Attach the middle shelf to the spine
- STEP 4: Attach the bottom shelf to the spine
- STEP 5: Align and attach the right side frame to the shelves
- STEP 6: Attach the right side frame to the top panel
- STEP 7: Attach the left side frame to the shelves
- STEP 8: Fasten the left side frame to the top panel
- Mounting the TV using the swivel configuration
- STEP 1: Attach the swivel bracket to the mounting frame
- STEP 2: Attach the swivel bracket assembly to the spine
- STEP 3: Attach the cable clips
- STEP 4: Select the correct bolts, washers, and spacers for your TV
- STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
- STEP 6: Option 1 - Mounting brackets on a TV with a flat back
- STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
- STEP 7: Attach the TV to the mounting frame on the swivel bracket
- STEP 8: Adjusting the tilt
- STEP 9: Position your TV stand and install the tipping restraint hardware kit
- Mounting the TV using the wall-mount configuration
- Mounting the TV using the tabletop configuration
- Maintaining your TV stand
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
23
3-in-1 TV Stand
STEP 7: Attach the TV to the mounting frame on the swivel bracket
You need:
1 With the help of another adult, lift the TV up to the mounting frame (I).
2 Set the hooks on TV brackets (J) over the mounting frame (I), then lower the hooks onto the bars of the mounting
frame.
3 Center the TV, then secure it in place using a Phillips screwdriver to tighten the safety bolt on the bottom hooks.
Tighten until the safety bolt hits the underside of the mounting frame.
Note: If you are wall-mounting the TV, go to Mounting the TV using the wall-mount configuration on page 26.
Phillips screwdriver