User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Assembling your stand
- STEP 1: Attach the top panel to the spine
- STEP 2: Attach the top shelf support to the top panel and spine
- STEP 3: Attach the middle shelf to the spine
- STEP 4: Attach the bottom shelf to the spine
- STEP 5: Align and attach the right side frame to the shelves
- STEP 6: Attach the right side frame to the top panel
- STEP 7: Attach the left side frame to the shelves
- STEP 8: Fasten the left side frame to the top panel
- Mounting the TV using the swivel configuration
- STEP 1: Attach the swivel bracket to the mounting frame
- STEP 2: Attach the swivel bracket assembly to the spine
- STEP 3: Attach the cable clips
- STEP 4: Select the correct bolts, washers, and spacers for your TV
- STEP 5: Determine whether your TV has a flat back or an irregular or obstructed back or a curved screen
- STEP 6: Option 1 - Mounting brackets on a TV with a flat back
- STEP 6: Option 2: Mounting bracket on a TV with an irregularly shaped or obstructed back or a curved screen TV
- STEP 7: Attach the TV to the mounting frame on the swivel bracket
- STEP 8: Adjusting the tilt
- STEP 9: Position your TV stand and install the tipping restraint hardware kit
- Mounting the TV using the wall-mount configuration
- Mounting the TV using the tabletop configuration
- Maintaining your TV stand
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
16
Mounting the TV using the swivel configuration
STEP 1: Attach the swivel bracket to the mounting frame
You need:
1 Align the four mounting holes on the swivel bracket (H) with the holes on the back side of the mounting frame (I). Make
sure that the hex nut on the swivel bracket and the two recessed holes on the mounting frame point in the same
direction.
2 Place a flat washer (R), then a lock washer (Q) over each of the mounting holes on the back of the swivel bracket (H).
3 Insert a 1/2" bolt (L) through the washers and into each of the threaded holes on the mounting frame (I).
4 Tighten the bolts with the 4 mm hex key (W).
Note: If you are wall-mounting the TV, go to STEP 4: Select the correct bolts, washers, and spacers for your TV on page 19.
Note: The hex nut and recessed holes point in the same direction.
H Swivel bracket (1)
I Mounting frame (1)
W Hex key 4 mm (1)
Q Lock washer (4)
R Flat washer (4)
L 1/2" bolt (4)
Hex nut
Recessed holes