User Manual
Table Of Contents
- Contents
- IMPORTANT SAFEGUARDS
- Features
- Package contents
- Tools needed
- Installation tips
- Assembling your stand
- STEP 1: Screw cam pins onto the drawer front panel
- STEP 2: Install the small wood dowls
- STEP 3: Assembly the drawer back panel and the drawer side panels
- STEP 4: Install the drawer bottom panel
- STEP 5: Install the drawer bottom support
- STEP 6: Install the drawer front
- STEP 7: Install the drawer handle
- STEP 8: Assembling the metal base
- STEP 9: Attach the metal base to the bottom panel
- STEP 10: Prepare the bottom panel assembly
- STEP 11: Prepare the top panel and partition panels
- STEP 12: Prepare the side panels, partition panels, and media shelf
- STEP 13: Attach the partition panels to the media shelf
- STEP 14: Install the media shelf
- STEP 15: Attach the side panels
- STEP 16: Install the back panel
- STEP 17: Install the door stoppers
- STEP 18: Install the top panel
- STEP 19: Secure the back panel to the partition panels
- STEP 20: Fasten the back panel
- STEP 21: Install the door hinges and handles
- STEP 22: Install the doors
- STEP 23: Install the adjustable shelves
- STEP 24: Insert the drawer
- STEP 25: Attach the stopper to the top panel
- STEP 26: Change the door panel
- STEP 27: Position the TV console and install the tipping restraint
- Maintaining your TV console
- Specifications
- ONE-YEAR LIMITED WARRANTY
www.insigniaproducts.com
7
Console for TVs up to 80”
Tools needed
Installation tips
Gluing wood dowels (U and X)
When using a wood dowel (U and X), put one drop of glue (SS) in the hole before you insert the wood dowel (U and X).
Insert the wood dowel (U and X), then gently tap it with a rubber mallet to secure it in place.
Locking cam pins (V) and cam locks (W and Y)
1 One end of a cam pin (V) is threaded so that it screws into place. The other end is not threaded. Before you insert the
un-threaded end into a hole, insert a cam lock (W and Y) into the hole and make sure that the hole in the cam lock (W
and Y) faces the outside edge of the part being used.
2 Insert the un-threaded end of the cam pin (V) through the hole in the part being used and into the cam lock hole, then
rotate the cam lock (W and Y) clockwise with a screwdriver to lock the cam pin (V) into place.
3 Insert a PVC cover (DD) into the cross slot of the cam lock (W and Y) to conceal.
Phillips screwdriver
Hammer
1/8” drill bit
Power drill
Rubber mallet
Pliers
312 4
GL
U
E
PAN E L
Cam pin
Pre-drilled hole
Cam lock
Locked panel
PVC cover