Flat Screen TV User Guide

8
NS-FTV27 27-inch Flat Stereo Color TV
www.insignia-products.com
Connecting the television to a DTV receiver or
set-top box
If you connect a DTV receiver/set-top box,
connect your television to it by using a
component video cord.
Using an AV amplifier with built-in digital surround
If you are using an amplifier with built-in digital
surround sound as follows, you can enjoy
various audio systems including Dolby Digital
Surround audio that sounds just like the movie.
Connect an AV amplifier with built-in Dolby
Digital decoder as shown below.
Connecting the television to a camcorder
To play back from a camcorder, connect the
camcorder to the television as shown.
Connecting the television to a video game console
The television can also be used as a display
device for many video games. However, due to
the wide variety of signals generated by these
devices and subsequent connection variations
required, they have not all been included in the
suggested connection diagrams. You'll need to
consult each component's owner's manual for
additional information.
Starting setup
The STARTING SETUP menu appears the first
time you turn on the television, and helps you
select the menu language, specify the
TV/CABLE setting, and program your channels
automatically.
To complete initial television setup:
1 Make sure that the antenna or cable
television system is connected.
2 Press POWER. The starting setup function
begins and the language setup menu
appears on the screen.
3 Press
or to select your desired
language, then press ENTER.
4 Press
or TV or CABLE, then press
ENTER.
5 Press
or to select START, then press
ENTER.
If you select CANCEL and press ENTER, the
STARTING SETUP stops and changes to the
television screen.
The AUTO SETUP starts. After the
STARTING SETUP is completed, the
television channel appears on the screen.
Depending on the reception condition, it may
take approximately ten minutes to complete
memorizing digital cable channels.
Notes
• When you make the connection above,
on the AV amplifier, do not set DOLBY
DIGITAL to DOLBY DIGITAL ON. If you
do, a loud noise emits from the
speakers possibly causing damage to
your hearing or to the speakers.
• This TV is not compatible with DTS
audio. There will be no sound output if
connected to an AV amplifier with a
built-in DTS decoder.
To Component
OUT
Video cord
(not supplied)
Audio
cord (not
supplied)
To Audio
OUT
To COMPONENT
IN
Surround Speaker
(Left)
Surround
Speaker
(Right)
Front
Speaker
(Right)
Front
Speaker
(Left)
Subwoofer
AV Amplifier with
built-in digital
surround decoder
as listed above
Coaxial Digital
Audio Output
Coaxial
digital
cable
(not
supplied)
to
Coaxial
Digital
Audio
Input
Center
Speaker
Audio/Video cord
(not supplied)
To Audio/Video
OUT
Front of the TV
To Audio/Video
OUT
Audio/Video cord
(not supplied)
Front of the TV
Video
Game
Console