Installation Guide

7
Pedestal for Insignia Washer and Dryer
www.insigniaproducts.com
STEP 3: Preparing your pedestal
1 Pull the pedestal drawer out as far as it will go.
2 Squeeze the lever release on each of the drawer slides, then pull out the
drawer and set it aside.
3 Remove the four support pads from the parts package. Press the two
protrusions on a pad into a corner hole on the top of the pedestal. Repeat this
step to install the other three pads.
Note: When laying the pedestal on its side, place the packaging foam that came
in the box under the pedestal.
Packing foam
Lever release