Installation Guide

5
Pedestal for Insignia Washer and Dryer
www.insigniaproducts.com
Installing your pedestal
STEP 1: Preparing to install
1 If the washer or dryer is already installed:
• Unplug your washer or dryer’s power cord from the power outlet.
• Disconnect the inlet hose(s) attached to faucet(s).
• Disconnect the drain hose and drain all hoses.
2 Remove the pedestal packaging.
3 Remove the pedestal organizer that is taped to the top of the shipping carton
and set it aside for final installation.
4 Flatten the box to use as a pad to lay the washer or dryer down on its side to
protect the finished floor in front of the installation location.
5 Do not try to stack two or more pedestals.
STEP 2: Removing the leveling legs and mounting screws
You need:
CAUTION:
• Do not lay the washer or dryer on its back.
• Do not remove the shipping bolts on the back of the washer. The bolts must
remain in place until the washer is returned to an upright position.
8 mm socket wrench
17 mm open end wrench or
adjustable wrench
OR
WITH
Electric screwdriver
8 mm socket