User Guide

27
www.insigniaproducts.com
8 Cu. Ft. Electric and Gas Dryers
INSTALLATION INSTRUCTIONS
2 Connect one end of the exhaust ducting to the venting hole on the back of
your dryer, then use aluminum tape to secure the ducting to your dryer. The
crimped ends of the duct sections must point away from your dryer. Use a 4 in.
(10.2 cm) diameter rigid metal duct.
3 Connect the other end of the ducting to the exhaust hood, then tighten the
duct strap to secure it in place. Tape all joints, including at the dryer.
Step 4: Connect the water supply
The water supply lets you use your dryer’s steam function.
t
1 Connect the Y-connector directly to the cold water supply or to an extension
hose (not included). Make sure that the Y-connector is snug by hand, then
tighten another 2/3 turn with pliers.
Tip: Wrap plumber’s tape (not included) around threaded connections to
prevent leaks.
Exhaust ducting Back venting hole
Exhaust hood
Cold water
Extension hose (optional/not included)
Y-connector