User Guide

24
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
5 Insert the elbow/duct assembly through the rear opening and press it onto
the adapter duct. Secure in place with duct tape. The male end of the duct
should protrude 1.5 in. (3.8 cm) out of your dryer to connect the remaining
ductwork.
6 Attach duct tape to the back of your dryer to seal the original dryer vent hole.
Installing your dryer
Tools you will need
Parts supplied
Important: We recommend that you use a qualified installer to install your
dryer.

Elbow/Duct assembly
Duct tape

Pliers
Phillips screwdriver
Level
Duct tape and
plumber’s tape
Adjustable wrench that opens
to 1" (2.5 cm)
Cutting knife
Flathead screwdriver
Pipe wrench
Y connector Short inlet hose