User Manual

www.insigniaproducts.com
14
If the G-sensor is triggered, your dash cam wakes up and
records one minute of emergency video, then returns to
sleep mode. Within one minute, your dash cam checks
the G-sensor. If the G-sensor is triggered again, your dash
cam starts loop recording for five minutes, then it turns
off and enters park mode.
Recording an emergency video
An emergency recording automatically starts when the
G-Sensor registers an impact. Emergency recordings
create protected (locked) files that are not overwritten by
the continuous loop recording. In addition, to make sure
that important footage isn’t lost surrounding an incident,
adjacent video clips are locked if the incident happens
within 10 seconds of the beginning or end of a clip.
You can manually start and stop an emergency video.
• When your dash cam is turned on, press the
Emergency Recording button to start recording. Press
this button to stop recording and save the clip. Press
this button again to save the next clip in progress.
Recording video
1 Make sure that your power cable is connected and
the MicroSD card is inserted.
2 After the car is powered on, your dash cam turns on
automatically and start recording.
Note: When the emergency recording partition is
full, your dash cam displays Emergency video file is
full! Save the files you need to keep to a computer.
See Downloading files to a computer
on page 15.
If you don’t clear the emergency clips, each time a
new emergency clip is recorded, you see the
message and your dash cam deletes the oldest
emergency video.