User Manual

6
NS-CZ14WH2/NS-CZ14WH2-C
www.insigniaproducts.com
Making electrical connections
• This freezer should be properly grounded for your safety. The power cord of
this freezer is equipped with a three-prong plug which mates with standard
three-prong wall outlets to minimize the possibility of electrical shock.
• Do not, under any circumstances, cut or remove the third ground prong from
the power cord supplied.
• The refrigerator must be installed with all electrical connections in accordance
with state and local codes. A standard electrical supply (115 V AC only, 60 Hz),
properly grounded in accordance with the National Electrical Code and local
codes and ordinances is required.
• This freezer is not designed to be used with an inverter.
• The cord should be secured behind the freezer and not left exposed or
dangling to prevent accidental injury.
• Never unplug the freezer by pulling the power cord. Always grip the plug
firmly and pull straight out from the receptacle.
• Do not use an extension cord with this appliance. If the power cord is too
short, have a qualified electrician or service technician install an outlet near
the appliance. Use of an extension cord can negatively affect the performance
of the unit.
Finding a suitable location
• Your freezer is designed to be free standing only, and should not be recessed
or built-in.
• Place your freezer on a floor that is strong enough to support your freezer
when it is fully loaded.
• Allow 6 inches (15 cm) of space between the back and sides of your freezer
and any surrounding walls to provide correct air ventilation. Adjust the feet to
keep your freezer leveled.
• Locate your freezer away from direct sunlight and sources of heat, such as a
stove, heater, or radiator. Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Extremely cold
temperatures may also prevent your freezer from performing correctly.
WARNING
Improper use of the grounded plug can result in the risk of
electrical shock. If the power cord is damaged, have it replaced by
an authorized service center.