User Manual

7
130-Can Beverage Cooler
www.insigniaproducts.com
Control and display panel
Setting up your beverage cooler
Before using your cooler
• Remove the exterior and interior packaging.
• Let the cooler stand upright for approximately half an hour before connecting
it to power. This reduces the possibility of a malfunction in the cooling system
from improper handling during transportation.
• Clean the interior surface with a damp, warm cloth.
Finding a suitable location
• This cooler is designed to be free standing only, and it should not be recessed
or built into a countertop or wall.
• Place your cooler on a floor, counter top, or cabinet that is strong enough to
support the cooler when it is fully loaded.
• Allow 1.6 in. (4 cm) of space on all sides of the cooler to allow for proper air
ventilation.
• Place the cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Ambient temperature below 50° F
(10° C) or above 86° F (30° C) will hinder the performance of this cooler. This
cooler is not designed for use in a garage or any other outside location.
BUTTON FUNCTION
• Press to turn the power on or off.
• Hold for three seconds to set your cooler to “Standby” mode.
Press to turn the interior light on or off.
Press to increase the temperature by one degree.
Press to decrease the temperature by one degree.
Press both buttons simultaneously to change the display from F° to C° or
back again.
Notes:
• Touch the control panel lightly when pressing the keys.
• To avoid scratching the control panel, do not touch it with sharp objects.
LED Display
Standby
Temperature +/-Light