User Manual

15
130-Can Beverage Cooler
www.insigniaproducts.com
Troubleshooting
Error codes
If a fault is detected, the display shows one of the following codes:
• E1: Temperature sensor fault
• E4: Defrost sensor fault
If any of these error codes appears on the display, contact your local dealer or
service center. Do not try to repair the cooler yourself.
Specifications
PROBLEM SOLUTION
The cooler does not
operate.
• Make sure that the cooler is plugged in and that
the plug is pushed completely into the outlet.
• Check the house fuse/circuit breaker box and
replace the fuse or reset the circuit breaker.
• If a power failure occurs, the cooler turns off. Wait
until the power is restored, then turn it on again.
The cooler door does not
close completely.
• Adjust the shelf properly.
• Clean the door gaskets.
• Level the cooler with the leveling feet.
The cooler is not cold
enough.
• Make sure that the door is closed properly.
• Allow time for new beverages to cool, then check
again.
• Set the control to a colder setting.
The cooler makes unusual
noises or vibrates.
• Level the cooler with the leveling feet.
• Move the cooler out from the wall.
•This is normal.
Moisture is building up in
the interior of the cooler.
• Make sure that the door is closed properly.
• Move the cooler to a dryer location.
The cooler turns on and off
frequently.
• Make sure that your cooler is in a room that is
50~86° F (10~30° C) or place your cooler in a cooler
location.
• Make sure that the door is closed properly.
• Clean the door gaskets.
• Set the control to a colder setting.
Dimensions (WxHxD) 21.46 × 33.66 × 22.2 in.
(54.5 × 85.5 × 56.5 cm)
Weight 94 lbs. (42.5 kg)
Power requirements 115 V~60 Hz
Current 1.2 A
Ambient operating
temperature
50°~85° F (10~30° C)
Cooler temperature range 34~50° F (1~10° C)
Power cord length 5.4 ft. (1.65 m)