User Manual

7
115-Can Beverage Cooler
www.insigniaproducts.com
Control and display panel
Setting up your beverage cooler
Before using your cooler
• Remove the exterior and interior packaging.
• Let your cooler stand upright for approximately half an hour before
connecting it to power. This reduces the possibility of a malfunction in the
cooling system from incorrect handling during transportation.
• Clean the interior surface with a damp, warm cloth.
Finding a suitable location
• Your cooler is designed to be free standing only, and it should not be recessed
or built into a countertop or wall.
• Place your cooler on a floor, countertop, or cabinet that is strong enough to
support your cooler when it is fully loaded.
• Allow 1.6 in. (4 cm) of space on all sides of your cooler to allow for correct air
ventilation.
• Place your cooler away from direct sunlight and sources of heat (such as a
stove, heater, or radiator). Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Ambient temperature
below 50° F (10° C) or above 85° F (29.4° C) hinders the performance of your
cooler. Your cooler is not designed for use in a garage or any other outside
location.
BUTTON FUNCTION
• Press to turn the power on or off.
• Hold for three seconds to set your cooler to “Standby” mode.
Press to turn the interior light on or off.
Press to increase the temperature by one degree.
Press to decrease the temperature by one degree.
Press both buttons simultaneously to change the display from F° to C° or
back again.
Notes:
• Touch the control panel lightly when pressing the keys.
• To avoid scratching the control panel, do not touch it with sharp objects.
LED Display
Standby
Temperature +/-Light