SECURITY CAMERA User Manual
Table Of Contents
- Contents
- Overview
- Before You Begin
- Installation
- Overview of Assembly Procedure
- Mount the HD16
- Connect the Power Cable
- Install the Camera Assembly
- Adjust the Camera
- DIP Switch Functions (Color and TDN Cameras)
- Adjustment Method (Color and TDN Cameras)
- White Balance Adjustment Method (Color and TDN Cameras)
- Manually Setting Shutter Speed (Color and TDN Cameras)
- DIP Switch Functions (WDR Cameras)
- Adjustment Method (WDR Cameras)
- Adjust the Line Lock (Vertical Phase) For External Sync Reference
- Adjust the Backlight Compensation
- Secure the Camera and Dome Enclosure
- Routine Maintenance
- Dome Replacement
- Solving Common Technical Issues
- Service
- Specifications
- Cable Guidelines
- HD16 Model Numbers
Document 900.0345 Rev 1.02 9
03/07
Connect the Power Cable
1. Follow Figure 4 for the wiring connection.
Figure 4 Wiring
2. Connect the power/video cable from the gimbal assembly to the camera
board (see Figure 5).
Note For secure installations, surface-mounted cables should be
protected by plastic or metal cable covers.
Figure 5 Power Cable Connection
Coaxial Cables UTP Cables
Video: Unshielded
Twisted Pair wire
Video: female BNC
Power
red +
connect to red +
black -
connect to ground
Power: 2.1 mm
male jack center pin
Gimbal assembly
Camera board
Power/video cable