SECURITY CAMERA User Manual
Table Of Contents
- Contents
- Overview
- Before You Begin
- Installation
- Overview of Assembly Procedure
- Mount the HD16
- Connect the Power Cable
- Install the Camera Assembly
- Adjust the Camera
- DIP Switch Functions (Color and TDN Cameras)
- Adjustment Method (Color and TDN Cameras)
- White Balance Adjustment Method (Color and TDN Cameras)
- Manually Setting Shutter Speed (Color and TDN Cameras)
- DIP Switch Functions (WDR Cameras)
- Adjustment Method (WDR Cameras)
- Adjust the Line Lock (Vertical Phase) For External Sync Reference
- Adjust the Backlight Compensation
- Secure the Camera and Dome Enclosure
- Routine Maintenance
- Dome Replacement
- Solving Common Technical Issues
- Service
- Specifications
- Cable Guidelines
- HD16 Model Numbers
Document 900.0345 Rev 1.02 17
03/07
Routine Maintenance
Use regular liquid cleaners to remove most dirt and grime from the HD16
enclosure.
Caution Do not use harsh or abrasive cleaners which can scratch the
polycarbonate dome and reduce visibility from the camera.
Dome Replacement
If the polycarbonate dome is damaged or scratched beyond use, contact your
distributor or salesperson to order a dome replacement. To replace the HD16
dome:
1. Use the security hex key (supplied) to loosen the #8-32 security screws
securing the HD16 lid to the base.
2. Use a Phillips screwdriver to remove the #6 x 1/4 inch Hi-lo tapping screws
that attach the dome retainer plate to the front cover.
3. Remove the damaged dome and replace it with the new dome.
4. Use a Phillips screwdriver to attach the dome retainer plate to the HD16 front
plate with the screws you removed in step 2.
5. Use the security hex key to tighten the security screws that secure the HD16
lid to the base.
Figure 13 Dome replacement
#8-32 security screws (x4)
Front cover
Polycarbonate dome
Dome turret
Gasket
Retainer plate
#6 x 1/4 inch Hi-lo tapping screws (x4)