SECURITY CAMERA User Manual
Table Of Contents
- Contents
- Overview
- Before You Begin
- Installation
- Overview of Assembly Procedure
- Mount the HD16
- Connect the Power Cable
- Install the Camera Assembly
- Adjust the Camera
- DIP Switch Functions (Color and TDN Cameras)
- Adjustment Method (Color and TDN Cameras)
- White Balance Adjustment Method (Color and TDN Cameras)
- Manually Setting Shutter Speed (Color and TDN Cameras)
- DIP Switch Functions (WDR Cameras)
- Adjustment Method (WDR Cameras)
- Adjust the Line Lock (Vertical Phase) For External Sync Reference
- Adjust the Backlight Compensation
- Secure the Camera and Dome Enclosure
- Routine Maintenance
- Dome Replacement
- Solving Common Technical Issues
- Service
- Specifications
- Cable Guidelines
- HD16 Model Numbers
10
Install the Camera Assembly
To install the camera assembly into the HD16 base:
1. Remove one of the three thumb nuts from the camera chassis (see Figure 6).
Loosen the other two thumb nuts.
2. Slide the gimbal ring under the two loosened thumb nuts.
3. Adjust the camera position. See “Adjust the Camera” on page 10.
4. Replace the thumb nut you previously removed in step 1.
5. Tighten all three thumb nuts to secure the camera assembly.
Make sure that the camera DIP switches are on the top of the lens mount
when the HD16 is mounted on the wall or ceiling.
Figure 6 Camera Assembly
Adjust the Camera
To adjust the HD16 Camera:
1. Apply 11-16 VDC or 24 VAC power to the camera and monitor the video
signal.
2. Loosen as many screws and thumb nuts that lock the gimbal assembly in
place as necessary to adjust the camera position (see Figure 6).
3. Adjust the camera carrier to the desired view by moving the gimbal in the V
groove (see Figure 7).
Loosen thumb
nuts (x2)
Remove thumb nut
Gimbal chassis
Gimbal ring