INSTALLATION GUIDE Fixed-Position Wall Mount for TVs 19–39 in. NS-HTVMFAB Before using your new product, please read these instructions to prevent any damage.
Safety information and specifications CAUTION: IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS READ THE ENTIRE MANUAL PRIOR TO USE Maximum TV weight: 35 lbs. (15.8 kg) Screen size: 19 in. to 39 in. diagonal Overall dimensions (H × W ): 8.66 × 10.04 in. (22.0 × 25.5 cm) Wall-mount weight: 2.2 lb (1 kg) We’re here for you CAUTION: Do not use this product for any purpose not explicitly specified by Insignia. Improper installation may cause www.insigniaproducts.com property damage or personal injury.
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in. Tools needed You will need the following tools to assemble your new TV wall mount: ardware Pencil Edge-to-edge stud finder Awl Socket wrench with 1/2 in. (13 mm) socket or adjustable wrench 7/32 in. (5.5 mm) wood drill bit (for wood stud wall) OR Phillips screwdriver 3/8 in.
TV Hardware Bag Label 02 03 Hardware Qty. M4 × 12 mm screw 4 M6 × 12 mm screw Label 07 M4 washer Qty. 4 4 08 04 Hardware M8 × 20 mm screw M6/M8 washer 4 4 09 05 M4 × 35 mm screw 06 M6 × 35 mm screw Spacers 4 4 11 Lag bolt washer 2 4 12 2 5/16 in. × 2 3/4 in. lag bolt Concrete Installation Kit CMK1 (not included) Contact customer service at 1-800-359-5520 to have these additional parts shipped directly to you. C1 2 5/16 in. × 2 3/4 in.
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in. Installation instructions STEP 1 - Determining whether your TV has a flat back or an irregular or obstructed back 1 Carefully place your TV screen face-down on a cushioned, clean surface to protect the screen from damages and scratches. 2 If your TV has a table-top stand attached, remove the stand. See the documentation that came with your TV for instructions. 3 Temporarily lay the TV brackets (01), oriented vertically, on the back of your TV.
STEP 2 - Select screws, washers, and spacers 1 Select the hardware for your TV (screws, washers, and spacers). A limited number of TVs come with mounting hardware included. (If there are screws that came with the TV, they are almost always in the holes on the back of the TV.) If you don't know the correct length of the mounting screws your TV requires, test various sizes by hand threading the screws.
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in. STEP 3 - Option 1: Attaching the mounting hardware to TVs with a flat back 1 Align the left and right TV brackets (01) with the screw holes on the back of the TV. Make sure that the brackets are level. 2 Install washers (07 or 08), and screws (02, 03, or 04) into the holes in the back of the TV. 3 Tighten the screws until they are snug against the TV brackets. Do not over tighten.
STEP 3 - Option 2: Attaching the mounting hardware to TVs with irregular or obstructed backs 1 Place spacers (09) over the screw holes on the back of the TV. 2 Align the left and right TV brackets (01) with the screw holes on the back of the TV. Make sure that the brackets are level. 3 Place washers (07 or 08) over the holes in the TV brackets. Insert screws (05 or 06) through the washers, TV brackets, and spacers. 4 Tighten the screws until they are snug against the TV brackets. Do not over tighten.
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in. STEP 4 - Determine wall-mount location Note: • For more detailed information on determining where to drill your holes, visit our online height-finder at: http://mf1.bestbuy.selectionassistant.com/index.php/heightfinder • Your TV should be high enough so your eyes are level with the middle of the screen. This is normally 40 to 60 in. from the ground. The center of your TV will be offset .80 in. lower than the center of the wall plate (10).
STEP 5 - Option 1: Installing on a wood stud* wall Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm). 1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder. 2 Align the center of the wall plate template (R) at the height (a + b) you determined in the previous step, make sure that it is level, then tape it to the wall. 3 Drill two pilot holes through the template to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit, then remove the template.
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in. STEP 5 - Option 2: Installing on a solid concrete or concrete block wall (requires Concrete Installation Kit CMK1) 1 2 3 4 CAUTION:To prevent property damage or personal injury, never drill into the mortar between the blocks. Mount the wall plate directly onto the concrete surface. Align the center of the wall plate template (R) at the height (a + b) you determined in the previous step, make sure that it is level, then tape it to the wall.
STEP 6 - Mounting the TV to the wall plate 1 If the locking screws (S) cover the bottom holes of the TV brackets (01), unscrew them until the holes are clear. 2 Holding the TV with the top of the screen tilted toward the wall, slide the upper notches of the right and left TV brackets (01) over the upper lip of the wall plate (10). 3 Push the bottom of the TV toward the wall until the latch mechanism clicks into place. HEAVY! You will need assistance with this step. 01 10 S 12 www.insigniaproducts.
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in. Securing the TV to the wall plate • Tighten the locking screws (S) with a Phillips screwdriver until they contact the wall plate (10). 01 01 01 10 10 S S S To remove the TV from the wall plate, unscrew the locking screws, then pull the bottom away from the wall and lift the assembly off the wall bracket. www.insigniaproducts.
ONE-YEAR LIMITED WARRANTY Definitions: The Distributor* of Insignia branded products warrants to you, the original purchaser of this new Insignia-branded product (“Product”), that the Product shall be free of defects in the original manufacturer of the material or workmanship for a period of one (1) year from the date of your purchase of the Product (“Warranty Period”).
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in.
Part Number: 6907-302035 www.insigniaproducts.com 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico) INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave. South, Richfield, MN 55423 U.S.A. ©2020 Best Buy. All rights reserved.
