User Manual

8
NS-WC29SS9/NS-WC29SS9-C
www.insigniaproducts.com
Finding a suitable location
• This cooler is designed to be free standing only, and it should not be recessed
or built into a countertop or wall.
• Place your cooler on a floor, counter top, or cabinet that is strong enough to
support the cooler when it is fully loaded.
• Allow 1.6 in. (4 cm) of space on all sides of the cooler to allow for proper air
ventilation.
• Place the cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Ambient temperature below
50° F (10° C) or above 85° F (29.4° C) will hinder the performance of this cooler.
This cooler is not designed for use in a garage or any other outside location.
• Avoid placing the cooler in moist areas.
• This unit is not designed to be installed in an RV or used with an inverter.
• Do not stack your cooler.
• For your cooler to operate normally, avoid placing it in areas with high
magnetic fields or high humidity.
Leveling your cooler
• It is very important for the cooler to be level in order to function properly. If
the cooler is not leveled during installation, the door may not close or seal
properly, causing cooling, frost, or moisture problems.
• To level your cooler, you may turn either leveling foot clockwise to raise that
side of the cooler or turn it counter-clockwise to lower that side.
18.9 in.
(48.0 cm)
33.1 in. (84.2 cm)
17.3 in. (44.0 cm)
29.9 in. (76.0 cm)