User Manual

9
4.1 Cu. Ft. Top-Load Washer
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
Control panel
#ITEM DESCRIPTION
1/Power button
Press to turn on your washer. Press again to turn off your washer. If you leave your washer on
and do not press the /Start Pause button within 10 minutes, your washer automatically
turns off.
2 Cycle selector
Turn to select a wash cycle. The cycle you select determines the wash pattern for the cycle. For
more information, see Washer options and settings
on page 26.
3 Digital display
• The initial display is the total time for the cycle you select.
• While your washer is running, the display shows the cycle process and time remaining in
the cycle.
Note: The time shown is an estimate based on normal operating conditions. External
factors (such as the load size, room temperature, incoming water temperature, and water
pressure) can affect actual time.
• If you set a delay time for the start of the cycle, the display shows the time when the cycle
will start.
4Soak button
Press to select the Soak option. Press again to cancel. Select this option for heavily soiled items
that need to soak to remove stains and heavy dirt.
Soak occurs after the tub fills and detergent is added, but before the wash process. The agitator
will rotate several times during the soak process.
5Extra Rinse button Press to add an extra rinse to the wash cycle. Press again to cancel.
6
/Start Pause
button
Press once to start the wash cycle. Press again to pause the cycle. If you pause the cycle, you can
add or remove items, but you cannot change any settings. Press again to restart the cycle.
7 Cycle status lights
Light to indicate what part of the cycle your washer is in. For example, the Soak light turns on
when your washer is in the Soak process.
8Delay button
Press to select a time when you want the cycle to begin. You can set the time up to 24 hours in
advance in one-hour increments. The display shows the time when the cycle will start. For more
information, see Step 5: (Optional) Set a delayed start time
on page 25.
9Soil Level button
Press to select the soil level. Different soil levels result in different washing times and wash cycle
settings. For more information, see Washer options and settings
on page 26.
10 Child lock
Press and hold the Soil Level and Temp buttons at the same time for three seconds to turn on
the child lock function. Press and hold these buttons again for three seconds to turn off the
function. When the child lock function is turned on, the only button that works is the
/POWER button and the Soil Level and Temp buttons you use to turn off the child lock.
11 Temp button Press to select the washing water temperature.
The rinse water temperature is always cold.
12 Water Plus button Press once to increase one higher water level. Press again to cancel this function. If the water
level is already set to the highest, the level will not change.
13
Fabric Softener
button
Add liquid fabric softener to the fabric softener compartment, then press this button.
The fabric softener is added to the cycle at the correct time.
NS-TWM41WH8A_17-0676_MAN_V3_EN.fm Page 9 Tuesday, August 15, 2017 2:12 PM