Quick Start Guide
V1 ENGLISH 18-0617
USING YOUR SCREEN
• Aim your projector at the front of the screen. The screen is not
intended for rear projection.
• You can run the pump continuously. However, turn the pump o
when leaving it unattended.
Weather restrictions
• You can use your screen in light weather conditions like gentle rain
or snow. Use during extreme weather conditions isn’t
recommended.
• Do not use in temperatures below 14°F (-10°C).
• Do not use in winds higher than 20 mph (32.2 km/h).
STORING YOUR SCREEN
1 Unplug the pump and open the zipper (in the back near the
bottom) to deate your screen.
2 Disconnect the air intake tube from the pump.
3 Remove the stakes from the ground and unclip the tethers.
4 Unclip the screen from the frame.
5 Carefully fold the frame and screen and store them in the included
carrying case.
MAINTAINING YOUR SCREEN
Frame
• Check the product at regular intervals for any signs of damage or
deterioration. Damage or deterioration could cause the product to
become unstable and a signicant safety hazard.
• If any part is damaged or deteriorated, stop use and contact the
manufacturer.
• Regularly check the condition of the ground stakes that hold the
screen in place. Damage to or deterioration of the stakes could
result in the screen becoming unstable and could result in serious
injury.
Screen
• Wipe the screen with a dry or damp cloth. Use only water or a
neutral, inammable, nontoxic cleaning and sanitizing solution.
• If water has soaked the screen, move it to a dry location, then plug
in the pump. The fan will dry your screen.
• If the inatable frame is covered in a light dusting of snow,
re-ination should not harm it. However, if it has been subjected to
a large amount of snow or ice, do not re-inate it. Instead, carefully
remove the screen from the extreme conditions (for example,
bring it indoors) and allow it to thaw before re-inating. This helps
prevent cracks in the material. Do not use in temperatures below
14°F (-10°C).
• Check the screen regularly for holes or other damage. DO NOT use
a damaged product. Use of a damaged product could result in
injury.
Pump
• Do not clean the pump with a chemical solution as this may
damage the coating and plastic parts. Never clean the pump in
water.
• Use a dry cloth to clean the foot holes and remove debris after each
use.
• Store the pump in a dry, indoor place that is out of the reach of
children.
• Regularly check the condition of the pump stakes. Damage to or
deterioration of the stakes could result in the pump becoming
unstable which could result in serious injury.
• Regularly check the condition of the pump’s power cord. Damage to
or deterioration of the cord could cause a serious electrocution
hazard. If the cord is damaged or deteriorated, immediately
discontinue use of the pump and contact the manufacturer.
To keep the power cord in good condition, hand-support the
product when carrying. Do not twist the cord.
TROUBLESHOOTING
The frame will not inate.
• Make sure that the pump is connected to a working power outlet.
The pump must stay on for the frame to stay inated.
• The zipper that seals the inatable may not be completely closed.
Make sure that the zipper is closed.
• The air-intake area may become clogged with grass, leaves, or other
debris. For best results, check this area and remove any debris.
• The hanging fabric of a partially-inated frame can become
attached to the motor’s air intake area. Make sure that that fabric is
not hanging near the motor during ination.
• Check for rips in the fabric. You can hand sew rips with any type of
thread or cover the tear with clear packing inatable screen tape.
• Make sure that the connection between the inatable and fan is
secure.
The frame is torn.
• You can hand sew rips with any type of thread or cover the tear with
clear packing tape.
The frame deates after unplugging the pump.
• This is normal. The screen will not stay inated unless the pump is
turned on.
SPECIFICATIONS
• Dimensions (inated)(H × W × D): 83 × 115 × 25 in.
(210.8 × 292.1 × 63.5 cm)
• Weight: 25 lbs. (11.3 kg)
• Electrical rating: 110-120V AC, 60 Hz, 0.8A
SAFETY INFORMATION
WARNING
• Keep children in your direct sight, stay close, and actively supervise them when
they are near this inatable. Assign an adult to supervise the inatable.
• Empty the inatable or prevent access to it when not in use.
• Store the empty inatable in a way that it does not collect water.
• Do not use in winds more than 20 mph.
Electrocution Risk:
• Keep all electrical lines, radios, speakers, and other electrical appliances away
from the inatable.
• Do not place the inatable near or under overhead electrical lines.
• Do not use extension cords with this product.
PUMP WARNINGS:
This product is only to be used for inating the inatable projector screen.
Household Use Only.
• Electrical current requirements: 110-120VAC/60Hz
• The power supply to the pump should include a grounding plug.
• The power cord to the pump should be clearly marked, so that persons using
lawn mowers or other types of equipment are aware that there is a cord on the
ground.
• The pump should never be left unattended when in use. The pump is not to be
used by children.
• No objects should cover the air intake when the pump is in use. Sand, small
stones, or other objects should not be allowed to be sucked into the pump.
• Under no circumstances should a nger or any sharp object be inserted into the
air intake.
• The power supply to the pump should not be exchanged for any other type of
supply. If the power supply is damaged, it should be repaired by a technician.
• To avoid the danger of electrical shock, do not immerse the pump in water.
• Do not use extension cords as this would present an electrocution hazard.
• Do not leave the pump exposed to strong sunlight.
• Operation of the pump is not recommended for children under 14 years of age.
As with all electric products, precautions should be observed during handling
and use to prevent electric shock.
• Children should not touch the pump. Children must not play on the product.
• Children should not attach foreign objects to the pump that are not specically
designed for use with the pump, such as, but not limited to jump ropes,
clothesline, pet leashes, cables, and chains as they may cause a strangulation
hazard.
• Sudden gusts of wind may lift the inatable o of the ground.
• Pumps and electrical cords should be kept out of reach.
• To avoid electrical shock, never plug in or unplug the pump with wet hands.
• The power supply should be disconnected if the pump or the inatable needs to
be moved.
• To reduce the risk of re or electric shock, do not use this pump with any
solid-state speed control device.
• Do not operate the pump with a damaged cord or plug. Discard pump or return
to an authorized service facility for examination and/or repair.
• Do not run the cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or appliances.
Grounding instructions:
• This product should be grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by providing an escape wire for the
electric current. This product is equipped with a cord containing a grounding
wire with an appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes
and ordinances.
• DANGER – Improper installation of the grounding plug can result in a risk of
electric shock. If repair or replacement of the cord or plug is necessary, do not
connect the grounding wire to either at blade terminal. The wire with
insulation having a green outer surface with or without yellow stripes is the
grounding wire.
• Check with a qualied electrician or serviceman if the grounding instructions
are not completely understood or if in doubt as to whether the product is
properly grounded. Do not modify the plug provided. If it will not t the outlet,
have the proper outlet installed by a qualied electrician.
• This product is for use on a nominal 120V circuit and has a grounding plug
similar to the plug illustrated. Only connect the product to an outlet having the
same conguration as the plug. Do not use an adapter with this product.
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call 1-877-467-4289 (U.S. and Canada) or
01-800-926-3000 (Mexico) www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2018 Best Buy. All rights reserved.
Made in China
READ ALL INSTRUCTIONS BEFORE ASSEMBLING THIS INFLATABLE DEVICE AND
KEEP INSTRUCTIONS FOR FUTURE USE.
FAILURE TO FOLLOW THESE WARNINGS AND INSTRUCTIONS CAN RESULT IN
SERIOUS INJURY OR DEATH TO USERS, ESPECIALLY CHILDREN.
GROUNDING METHODS
GROUNDED
OUTLET
GROUNDING
PIN
GROUNDED
OUTLET BOX
NS-SCR117_18-0617_QSG_V1_EN.ai 2 12/17/2018 3:34:08 PMNS-SCR117_18-0617_QSG_V1_EN.ai 2 12/17/2018 3:34:08 PM