User Manual

NS-PGSMM6120-C/NS-PGSMM6220-C

www.insigniaproducts.com

Step 2 - Option B: Assembling the grommet assembly

Select the position on the desk where you want your monitor mount

installed. Make sure that there is enough room for the monitor. The desk

should between 1.0-4.7 in. (25-120 mm) thick and strong enough to bear

the weight of your monitor. The grommet hole should be 0.3-2.8 in.

(8.5-70 mm) in diameter.

1 Insert the bolt (8) through the square hole on the grommet base

support (7).

2 Secure the grommet base support (7) to the monitor arm (1) with

three screws (C) and a hex wrench (G).

Note: If the screws are not flush, the base support is upside down.

Remove the screws and bolt, then turn over the base support.

3 Remove the backing from the grommet pad (3), then press it onto the

grommet base support (7).