User Manual

16
NS-HAWHP2
www.insigniaproducts.com
If the power indicators on the headphones and docking station
continue to blink once a second, they are no longer paired to each
other. If this happens, follow these steps:
• Make sure that the headphones and docking station are within
range of each other (ideally in the same room).
• Turn off the headphones and unplug the docking station.
• Turn on the headphones and plug in the docking station. The blue
LED on the headphones and docking station will blink every five
seconds when paired.
Listening to your headphones
1 Turn on the headphones and docking station. Make sure that your
docking station and headphones are paired. See “Turning on and
pairing the system” on page 15.
2 Set the headphone volume level to the minimum.
3 Put your headphones on your head. Adjust the fit until you feel
comfortable.
4 Turn on your audio source (such as a TV or stereo system) and begin
playback. You may need to turn up the volume on your audio source
to hear playback.
5 Adjust the headphone volume to your normal listening level.
NOTE: If the charge on the headphone batteries is low, the Power/Pairing indicator on
the headphones blinks red (three times a minute) and beeps (twice a minute). When
this happens, you should charge the headphones. For instructions, see “Using your
system“ on page 15.
CAUTION: Continuous use at high volume may permanently damage your hearing.
NOTES:
• If the system is connected to a TV, you may want to turn off the TV sound to
prevent hearing sound from the TV speakers. Refer to your TV manual.
• If the docking station does not have audio input for more than 15 minutes, the
headphones will power off automatically.
• If the headphones are unpaired from the docking station for more than 15
minutes, the headphones will power off automatically.