User's Manual
Table Of Contents
- Content
- CHAPTER 1 : Accesso description
- Chapter 2 connection
- Chapter 3 Command interface reference manual
- Chapter 4 User's Guide
- appendix A How to load a key in A coupler
- appendix B ERROR CODE
Accesso 2G - Datasheet - Accesso 2G
DS 13
Version 1.1
How to reset the coupler
Resetting the coupler may be useful to set the parameters (speed, disable mode, protocol
settings, keys ) to the defaults values. All these values are stored in coupler’s internal
EEPROM
Software reset
It is possible to reset the coupler’s EEPROM by sending 2 commands thanks to the SET
STATUS command.
Command = $80,$F4,$80,$3E,$01 - Data = $00
Command = $80,$F4,$80,$7E,$01 - Data = $00
Then the coupler has the default setting : 9600 bds, defaults protocols....