User's Guide
Table Of Contents
- Cover Page
- Contents
- 1 Introduction and Getting Started
- 2 Touchscreen
- 3 Admin Website
- 4 Advanced Settings
- 5 Troubleshooting and Support
- Overview
- Common Problems and Solutions
- My M2000 powered off without pressing the Power button
- No service is available
- My M2000 has no power/touchscreen doesn’t display when I press the Power button
- I forgot my Wi-Fi password
- I forgot my M2000 Admin website password
- I cannot connect a device to my M2000
- I see the network name, but cannot connect a device to my M2000
- I want to see how many devices are connected
- I want to see the firmware (software) version installed on my M2000
- I want to see the phone number for my M2000
- I want to see the battery level of my M2000
- I want to turn my M2000 off
- I want to know if my M2000 is still on when the touchscreen is dark
- Technical Support
- 6 Product Specifications and Regulatory Information
- 7 Glossary
5G MiFi M2000 USER GUIDE 53
GPS Driver
For the GPS over Wi-Fi feature, if you want to access the GPS data stream from a virtual COM port
instead of the TCP port (above), use the Download Driver button to download and install a GPS driver
for your Windows platform. This driver creates a virtual NMEA port, obtains GPS data from the M2000,
and makes this GPS data available to NMEA-aware third-party applications.
Current Location
Latitude: Latitude for the last location fix.
Longitude: Longitude for the last location fix.
Altitude: Altitude for the last location fix.
Accuracy: A measure of the accuracy of the horizontal position obtained by the GPS receiver.
NOTE: You can change the format of measurement (Feet or Meters) in Settings > Preferences > User
Preferences.
Advanced Tab
Advanced settings are intended only for users with advanced technical knowledge. For information
about the Advanced Settings page, go to Chapter 4, Advanced Settings on page 65.