User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Admin User Interface
- 3 Troubleshooting and Support
- 4 Product Specifications and Regulatory Information
- 5 Glossary
5G FW2000 CPE USER GUIDE 6
Getting Started
To turn on your FW2000 and connect a device:
1. Check that the PoE cable from the FW2000 is in the Data & Power Out port on the PoE power
injector and the PoE power injector is plugged into an earthed AC outlet.
2. Insert one end of a Cat6A Ethernet cable into the Data In port on the PoE power injector.
3. Insert the other end of the cable into the Ethernet port of the device you wish to connect.
WARNING! Use only the PoE power injector supplied with the FW2000. Unapproved power
supplies could cause overheating or fires, resulting in serious bodily injury, death, or property
damage. Do not defeat the safety purpose of a grounding-type plug. Use the PoE power injector
only in combination with an earth-socked outlet.