User's Guide
Table Of Contents
- Contents
- 1 Introduction and Getting Started
- 2 Admin User Interface
- 3 Troubleshooting and Support
- 4 Product Specifications and Regulatory Information
- 5 Glossary
5G FW2000 CPE USER GUIDE 23
Viewing Info About the FW2000
On the Web UI Home page, the General Status panel shows general Internet connection and system
information.
Carrier: The name of the Mobile Network Operator.
Technology: Indicates the current cellular data connection, for example, 5G Sub6.
Band: The band in use for the current connection.
PCI: The Physical Cell ID.
SIM Status: The current status of the SIM card.
WAN: The current status of the WAN connection.
MDN: The phone number of your FW2000.
IMEI: The International Mobile Equipment Identity (IMEI) for your FW2000. This is a 15 digit code used
to uniquely identify an individual mobile station. The IMEI does not change when the SIM is changed.
Signal Strength (RSRP): The strength of the cellular signal, measured in dBm. Higher absolute values
indicate a stronger signal, for example: -80 dBm is a stronger signal than -90 dBm.
SINR: Signal to Interference plus Noise Ratio. An LTE-specific measure of signal quality, taking
interference and noise into account. SINR is a positive value, and higher numbers are better.
FW Version: The version of the firmware (software) currently installed on your FW2000.
IPv4: The network IP address assigned to your computer, not your FW2000 device.