Installation Guide

Orienting the device
1. Run the PoE cable to the desired location of the
PoE injector.
2. Attach a RJ45 connector fitting and insert the
cable into the Data & Power Out port on the
PoE power injector.
3. Take a racheting socket wrench and device/
smartphone with the Inseego Mobile App to
the FW2000e location.
4. Use the Inseego
Mobile App and
the positioning
bolts on the
device elevation
bracket and
bottom of
the mount to
fine tune the
horizontal and
vertical angle of
the FW2000e for
the best signal.
5. Tighten the
positioning bolts
to 15.0 Nm.
6. Use sealing/weatherproofing material to seal
any holes drilled in the structure to run the PoE
cable.
LED Color Operation Meaning
Blue Solid
Blinking
Strong 5G connection (3 – 5 bars)
Weak 5G connection (1 – 2 bars)
Green Solid
Blinking
Strong 4G connection (3 – 5 bars)
Weak 4G connection (1 – 2 bars)
Yellow
Solid Software update is in progress
Red Solid
Blinking
Router is booting up
No service, SIM error, or locked SIM card