Installation Guide

Orienting the device
1. Run the PoE cable to the desired location of the
PoE injector.
2. Attach a RJ45 connector fitting and insert
the cable into the PoE port on the PoE power
injector.
3. Take a racheting socket wrench and device/
smartphone with the Inseego Mobile App to
the FW2010 location.
4. Use the Inseego
Mobile App and the
positioning bolts on
the device elevation
bracket and bottom of
the mount to fine tune
the horizontal and
vertical angle of the
FW2010 for the best
signal.
5. Tighten the
positioning bolts to
15.0 Nm.
6. Use sealing/
weatherproofing
material to seal any
holes drilled in the structure to run the PoE
cable indoors.