ASSEMBLY INSTRUCTIONS Style # C1281 Console Table NOTE TO CUSTOMERS: For ease and speed of assembly we recommend that before you commence each step of the assembly that you identify all the parts required to complete that step. ‘We recommend that where possible you allow sufficient space to assemble the item as close as possible to the place where it will be once assembled.
To insert a cam lock: (Please read below instructions before assembling) L Jfi:? ® & 1. Insert cam screw into hole as shown in diagram A . Make sure not to insert the cam screw: Too deep as shown in figure B as this will cause the cam screw to be misaligned and unable to interlock properly. Also avoid inserting the cam screw too close to the surface of the hole as shown in figure C, as this will cause the cam lock to be too loose, and not interlock properly. 2. Connect the panels together. ARROW SIGN 3.
Part List % Al: Top Panel 1pc | A2: Left Side Panel 1pc | A3: Right Side Panel 1pc R Ad: Bottom Panel 1pc & AS: Shelf 1pc N A6: Divider PCs \ AT7: Apron PCs = A8: Drawer Front Panel PCs N A9: Drawer Side Panel ~ PCs \\ A10: Drawer Back Panel PCs <> All: Drawer Bottom Panel PCs ~ Algal: Back Panel 1pc -Page 3 of
Hardware List Handle with bolt B1 : Cam lock tsetse |B2: Wood dowel PCs sets % ” B4: Stopper with screw sets B5: Screw PCs B6: Screw PCs Anchor with screw . 1st B8: Anti-tip kit 1st Step 1 B4: %’ sets Attach Stoppers (B4) to the bottom of Shelf (AS) using included Screws .
Step 2 Bl:@, tsetse Assemble Bottom Panel (A4) to Dividers (A6) using Cam locks (B1) and Wood Dowels (B2).
Step 4 Bl tsetse B2: PCs ‘Wood Dowels (B2). Step 5 Bl:@, a—=s sets B2: = PCs Assemble Top Panel (A1) to Side Panels (A2&A3) and Aprons (A7) using Cam locks (B1) and Wood Dowels (B2).
Step 6 B6: w PCs Attach Back Panel (A12) to the back of this unit using Screws (B6). Step PCs, 1): Insert Drawer Bottom Panel (A11) into the grooves on Drawer Front Panel (A8). 2): Attach Drawer Side Panels (A9) to Drawer Front Panel (A8) using Screws (BS, please make sure Drawer Bottom Panel (A11) inserted into the grooves on Drawer Side Panels (A9).
B3: ~) tsetse B5: «s PCs 1): Attach Drawer Back Panel (A10) to Drawer Side Panels (A9) using Screws (BS). 2): Attach Handle (B3) to Drawer Front Panel (A8) using included Screws . Insert drawers into this table.
APPENDIX: Dimension of Hardware in this Bolt for Handle B1. B2.
