User's Manual

Table Of Contents
4.It will alarm automatically after 2 seconds
when emergence and pressing SOS button.
5.P1/P2/P3/P4 keys are customized, you can
define quick contact or group.
6. Press return button to exit platform and
back to the main interface.
:security information
Before using the equipment, please read and follow
the precautions as below, to ensure the best
performance of equipment, and avoid dangerous or
illegal situations.
Electronic equipment.
Where there are civilized regulations prohibiting
the use of wireless devices, please do not use the
equipment, other wise it will interfere with other
electronic devices or lead to other dangers.
The flammable and explosive area.
In the gas station (maintenancestation) or near
Release PTT to finish the talk
Receive message
3. Volume Adjustment
The radio volume can be adjusted by volume
keys.
Adjust volume via sliding volume bar
PTT
3.
到的息列表,以进
访
便
个性设置。包无线
、电、应用、置信
和重、添加账、日
使
1.
. IP
2.
PTT
使
使
使中性涤剂(不使用
使用波炉或吹机等
使
TM 7 P us)( l
耳机/USB接口
上翻
下翻
返回键
LOGO标贴
SOSLCD
状态指示灯
开/关机键
旋钮键
手咪接口
SIM卡切换键
2/3G网络切换键
P3客户自定义键
P4客户自定义键
固定支架螺丝
固定支架
SIM卡插卡槽
使
、蒸等)下使车台
将它在加
湿,也要将
使使用 险性
指南,不形式产品为准,
;
;
;
;
;
SIM卡插卡槽
SIMSIM
顺时针旋转,直到旋紧为止,注意对应天线
2
Dc电源接口
GPS天线接口
外置主天线接口(保留按键:客户要求外置天线时使用)
4
插入GPS天线/外置主天线
5
插入SIM卡,盖上SIM卡盖并锁紧螺丝
手咪接口
开机按钮,直显示
SIMPIN
PINPINPIN
1234
屏幕端的状态,拽
打开示栏。系提示
此外系统提示还会
(如 ),
击 图
个性设置界面在个
添加部件,以进行
,可行相应图的移
即 清
GSM/GPRS/Edge: B2/B3/B5/B8
WCDMA/HSPA: B1/B2/B5/B8
FDD-LTE: B1/B3/B7/B8/B20
TDD-LTE: B38/B40/B41
User manual
Thank you for purchasing our machine
Headset /USB interface
Turn up
Turn down
Return
LOGO
SOS
LampLCD
Indicator
On /off
Knob key
Mic
interface
SIMswitch key
2G/3G switch key
Customized button
Customized button
Fixed bracket screw
Fixed
bracket
SIM inserting slot
Instructionsbefore use:
Do not use the mobile radio or charge the
battery in the explosive environments (such as
gas, dust, steam,etc.);
In the gas or parking on the gas stationplease
turn off the mobile radio; The machine can not
be modified or adjusted for any reason;
Please don't let the mobile radio stand in
sunlight directly for a long time, or put it nearby
the heating appliances;
Do not place mobile radio in extremely dusty,
moistureand water splashing places, and do not
put in uneven surface.
Maintenance can only be carried out by
professional and technical personnel, Please do
not disassemble by oneself.
Security:
Please read this user manual carefully. It is ver y
important for users to understand and be
familiar with the general danger of using.
This guide is just for reference only and does not
constitute any form of commitments.
Machine Chart:
SIMinserting
slot
SIMSIM
Installation:
1
Insert the SIM card, cover on the SIM holder and tighten
the screws.
Rotate clockwise until the antenna is tightened.
and pay attention to the antenna.
2
3
Connect with the power supply.
4
Insert GPS antenna / external main antenna.
5
Plug in the microphone.
Hand microphone interface
Message
Click into the message interface, it will display the
list of message received, you can edit, send, and
delete message.
Calendar
It allows you to access your calendar and eventsat
any time. You can view the calendar respectively,
You can also view several calendars at the same
time. Go to the top of calendar to option that
thecalendar viewed by day, week, or by month.
Open the week (month) toview, the calendar will be
displaye d by w e e k ( m onth) way. It 's more
convenient for you to look at calendar and new
items.
Settings
Enterthemenu to personalize the mobile radio
according to the need. Including wireless and
network ,contextual model, display, storage, batter y,
application, location information, security, and
language and typewriting, backup and reset, add
account, date and time, the auxiliary function, print,
developer options, about mobile phones, etc.
Operation guide
1.Input account and password.
The user configure IP based on the platform server and
then login.
2. Communication
Access to intercom platform, choose the contact or
group, press microphone PPT to talk,
Functions:
English
1
插入SIM卡,盖上SIM卡盖并锁紧螺丝
3
插入DC电源
4.当SOS2
5.P1/P2/P3/P4
6.退
Red light means sending
Green light means receiving
收绿
讲发灯亮
(左右旋转调整音量
大小,下压确定)
GPS天线接口
外置主天线接口(保留按键:客户要求外置天线时使用)
DC电源接口
GPS antenna interface
External main antenna interface (To Reserve)
DC power interface
Dc Power Input
GPS antenna interface
External antennacustomized
To Reserve
flammable and explosive materials, chemicals and
any other explosive areas, please do not use the
equipment, equipment may cause fire or explosion.
Operating environment
Please do not use equipment in dusty, humid, air
dirty or near the magnetic field, so as to avoid
internal circuit fault.
Please do not use the equipment in thunderstorm
w e a t h e r, t h u nder s t o r m w e a t h er ma y c a u s e
equipment failure or electric shock risk
Do not place the equipment in sunlight directly for a
long time .
Please avoid equipment and accessories rain
ormoisture, otherwise it may lead to the risk of fire
or electric shock
Don't put the equipment near the heat source or the
exposed fire source, such as electric heater,
m i c r o w a v e o v e n , ov e n , w a t e r h e a te r, f i r e
furnac e , c a n dle or ot h e r p l aces wh e r e high
temperature may occur.
Accessories requirements
Do not use an unapproved or incompatible power
source, charger or battery, which may cause fire,
explosion, or other hazards.
Please only use the accessories approved by the
equipment manufacturer and equipped with this
equipment. if using other types of accessories, and
it will occur accidental damage to the equipment,
Also violate warranty clause of the equipment.
Maintenance Service:
Before cleaning and maintaining the equipment,
Firstly ,stop using the equipment, turn off the power
supply, and disconnect all the connections on other
equipment.
When you do not use the mobile radio, please cover
the socket Jack interface.
When cleaning the dust on the exterior of the truck
radio, please use neutral detergent (no strong
corrosive chemicals) to wipe it.
Please keep theequipment and accessories dry .
Please do not use the microwave oven or hair dr yer
and other heating equipments for drying on it.
(Turn left or right to
adjust the volume
Press OK)
First boot:
Make sure the power is plugged in. Boot: press and
hold the button until the screen appears on the
screen.Some SIM cards will have pin code protection.
If there is an input pin code prompt, please input
your PIN code.The initial password of PIN code
is1234.
Unlock the screen
Press the hang button to lock the screen, and then
click the buttonagain to wake up the screen.
System prompt bar
The way to open the prompt bar: press on the top of
the screen, grabbedthe pop-up drop-down box drag
down to open the prompt bar.The system prompt bar
displays the currently opening applications.Click on
the running list bar can quickly switch to the
corresponding application.
Friendly note: You can't dial the phone when you
open the flight mode. In addition, the system prompt
column displays the current notifications of the
system(the unread text messages,etc.),and running
applications. Click this icon can view icon list.Click
it can quickly open the corresponding function.
Personalization
long pressin the blank space of the main screen can
access to personalized settings interface.
you can set wallpaper, add widgets, and set the
system.
Move or delete Icon
Long press the menu in the screen or widget icon,the
corresponding icon can be moved or deleted.
Factory Reset
Select "backup & reset" in the settings menu,and
then the factory settings can be restored.
Warning: restore the factory settings will reset the
phone to its initial factory status, that means clean
the system, application data and settings, including
downloaded applications.
Network
GSM/GPRS/Edge: B2/B3/B5/B8
WCDMA/HSPA: B1/B2
/
B5/B8
FDD-LTE: B1
/B3
/B7/B8/B 2
Basic functions:
4
TM 7 P us)( l
/B4
/B2
/
B5
/B4
1
/B
1
3
/B
1
7

Summary of content (2 pages)