User's Manual

APTIO - Operations Manual 2-7
799.007.203.0— February 2011
Section 2 Security
Manufacturer
This equipment is manufactured by Inpeco S.p.A. in Borgone di Susa factory plant.
www.inpeco.com
Inpeco S.p.A
Via G. Di Vittorio, 11 - Segrate (MI) - ITALY
Phone [phone] - Fax [phone].
Viale Europa, 14. Borgone di Susa (TO) - ITALY
Phone [phone] - Fax [phone].
Waste Disposal
Dispose of all waste produced during the workcell operation according to local, state,
and country regulations.
Treatment of waste electrical and electronic equipment.
The product at the end of its useful life, should be disposed of following the rules for
disposing differentiated and can not be treated as a simple urban waste.
The product should be disposed of at collection centers or dedicated shall be returned
to the dealer if you want to replace it with another equivalent new.
Figure 2.1: Waste symbol
Indicates that the product meets the requirements of the new guidelines introduced to
protect the environment (2002/95/EC, 2002/96/EC, 2003/108/EC) and must be disposed
of properly at the end of his life cycle.
Request information from local authorities about the areas devoted to waste disposal.
Who does not dispose of the product by following the instructions in this section
responds according to current regulations.
Hazardous substances
Precaution should be taken handling tubes. Tube handling must be done using protective
gloves and protective goggles. Automation system operators should follow Clinical
Laboratory Safety (i.e: NCCLS document GP17-A2-Clinical Laboratory Safety; Approved
Guideline-Second Edition).
IMPORTANT: Do not allow bleach or soapy water to spill through the
Automation cover, or set any bleach solution or soapy water containers
on the Automation surface. This could lead to contamination of samples,
possibly causing erroneous patient results.