Installation Instructions

2
QSR Performance Solutions Drive Thru System - Operating Instructions
Connecting Headset to Belt-Pack
• The 2 prong headset connector plugs into the bottom of the belt-pack
Headset
Jack
Programming the Belt-Packs
• Belt-packs must me programmed to the base station before they will operate properly
• Programming station should already be plugged into base station
• Make sure power indicator on base station is lit
• Insert battery in belt-pack
• Make sure belt-pack power is turned OFF
• Insert belt-pack into programming station
• Turn belt-pack power ON
• Power indicator on belt-pack will flash green during programming (about 5 seconds)
Programming Station Belt-Pack in Programming Station