Product Manual

“BATTERY CHECK” LEDs start flashing, immediately release the buttons.
The “BATTERY CHECK” LEDs will flash in sequence as the POC makes
communication attempts with the External Battery. If communication
is established, the EXT LED will illuminate solid green and the External
Battery will begin charging. If no communication is established, the LEDs
will flash for two minutes and then stop flashing. If this occurs or this
procedure doesn’t work for you, please call Inova Labs Customer Care at
512.617.1744 for assistance.
3. It can take up to 2 hours for a fully discharged External Battery to reach
a full charge. Refer to the EXT Battery Bar on the display screen to check
the charging progress. Each segment in the Battery Bar represents 25%.
When the External Battery is fully charged, the message “Charging EXT”
will disappear from the display screen.
NOTE: By design, the External Battery will power the device when
plugged in. Once the External Battery depletes, the device will switch
to Internal Battery power. If both the Internal and External batteries
are fully discharged, it can take up to 6 hours to achieve a full charge
in both batteries.
In the event the power supply is interrupted to the device when the AC or DC
Power Supply is connected, a two-second audible alarm will sound and the
compressors will transition from external to internal power.
NOTE: If the POC is powered off and either the AC or DC Power
Supply is connected, the internal fans will continue to operate until the
temperature inside the unit is sufficiently cooled.
12
OPERATING
INSTRUCTIONS
continued
* Hours are approximate and based on breaths per minute. As batteries age, charge times and
runtimes may change.
BATTERY LIFE TIMETABLE
Battery Type
Pulse Setting
1 LPMeq 2 LPMeq 3 LPMeq 4 LPMeq
Internal Battery* 10.25 Hours 8.25 Hours 5 Hours 4 Hours
External Battery* 4.75 Hours 3.75 Hours 2.75 Hours 2.25 Hours
BATTERY RECHARGE TIMETABLE
Battery Type Hours
Internal Battery* 4
External Battery* 2