User Manual

8
5. Smart Functions
Auto Shut Off
When the bucket is full and/or the set humidity level is reached, the dehumidifier will shut off automatically.
1) When the water bucket is full, the LCD will display an E7 code, the FULL icon will illuminate and the
dehumidifier will make a beep sound for a few seconds.
2) When the room humidity is down to the set-point, the 3 water-droplets icon and the humidity reading on
the LCD will flash.
3-Minute Delay Protection Mechanism
To avoid any damage to the dehumidifier, the dehumidifier will not start operation following a complete cycle
until after 3 minutes, which is called the 3-minute delay protection mechanism. That is to say, it takes 3 minutes to
restart the compressor when its operation has been interrupted. During this 3 minutes, only the fan is running,
and the water droplets icon will keep flickering until the compressor kicks in.
Auto Defrost
When the frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue to run
until the frost disappears. (* See details on Page 4 “Defrosting Icon”.)
Auto-Restart
If the dehumidifier shuts off unexpectedly due to power being cut, the dehumidifier will restart with the previous
function setting (mode, set humidity and fan speed) automatically when the power resumes.
6. Removing Collected Water
1) Emptying the Water Bucket
When the bucket is full, the dehumidifier will automatically shut down and make a beep sound for 5 seconds.
Meanwhile, the LCD will display an E7 error message and the FULL icon will illuminate. Do not move the
dehumidifier at this time in case the water spills on the floor.
To remove the bucket to empty the collected water:
a. Gently remove the bucket from the dehumidifier by holding the bottom and one side and pulling outward;
b. Pour the condensate out from the side without float to prevent the float from being flushed away with water.
c. Replace the water bucket in the dehumidifier. The dehumidifier will not function without the bucket being
installed.