User's Manual

©
2006 Copyright Innovative Wireless Technologies R1
FCC Statement for OEM Integrators
mProm™ Module Use for maintaining RF exposure
This device is intended only for OEM integrators under the following conditions:
1. Connection to the mProm™ Module should always be made through the 26 pin header.
Connection to the mProm™ Module any other way not expressed in this documentation or
approved by Innovative Wireless Technologies, Inc. will void the user’s ability to operate this
device under the FCC certification.
The header on the mProm ™ Module is a SAMTEC FTMH-113-02-L-DV, and mate connection is
CLM-113-02-L-D.
2. The mProm™ Module may not be co-located with any other transmitter or antenna.
3. The mProm™ Module is approved using the FCC “Unlicensed modular transmitter
approval” method. Therefore the mProm™ Module must only be used with the originally
approved antenna(s).
As long as the 3 conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain, co-
location with another transmitter, or different antenna), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
OEM End Product Labeling
The mProm™ module is to be installed in a OEM product without alteration. During installation,
do not remove the FCC ID information on the module. The final end product that has integrated
the mProm™ Module must be labeled in a visible area with the following: Contains TX FCC ID:
SP8-IXU1-ASY1168
IMPORTANT NOTE TO OEM
The end user of the OEM’s product, with incorporated mProm™ Module, should NOT be provided
any instructions on how to remove or install the mProm™ Module.