User's Manual

FCC Statement for OEM Integrators

AXON™ Module Use for maintaining RF exposure

This device is intended only for OEM integrators under the following conditions:

1. Connection to the AXON™ Module should always be made through the 20 pin header.

Connection to the AXON™ Module any other way not expressed in this documentation or

approved by Innovative Wireless Technologies, Inc. will void the user’s ability to operate this

device under the FCC certification.

The header on the AXON™ Module is a SAMTEC FTMH-110-02-L-DH, and mate connection is

CLM-110-02-L-D.

2. The AXON™ Module may not be co-located with any other transmitter or antenna.

3. The AXON™ Module is approved using the FCC “Unlicensed modular transmitter

approval” method. Therefore the AXON™ Module must only be used with the originally

approved antenna(s).

As long as the 3 conditions above are met, further transmitter testing will not be required.

However, the OEM integrator is still responsible for testing their end-product for any additional

compliance requirements required with this module installed (for example, digital device

emissions, PC peripheral requirements, etc.).

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain, co-

location with another transmitter, or different antenna), then the FCC authorization is no longer

considered valid and the FCC ID can not be used on the final product. In these circumstances,

the OEM integrator will be responsible for re-evaluating the end product (including the transmitter)

and obtaining a separate FCC authorization.

OEM End Product Labeling

The final end product that has integrated the AXON™ Module must be labeled in a visible area

with the following: Contains TX FCC ID: SP8-IWTBB1142

IMPORTANT NOTE TO OEM

The end user of the OEM’s product, with incorporated AXON™ Module, should NOT be provided

any instructions on how to remove or install the AXON™ Module.