User's Manual

Revised: 9/12/2017 5520-16-0281 Rev: C
Proprietary and Confidential Page 9 of 15
Figure 6 – Replace cover and tighten screws. Ensure the gasket is on the screw before inserting.
4.1.2 Replacing Batteries of FAP5015-027 Asset Tag
To insert or replace batteries:
 Open enclosure by unscrewing the four captive cover screw on the back/bottom side of the
enclosure.
 Remove Tracking Tag assembly from external enclosure.
 Follow battery replacement instructions in section 4.1.1.
 Place Tracking Tag assembly into foam insert in top side of enclosure. Ensure flat side of
Tracking Tag assembly is facing outward prior to closing up the enclosure.
 Make sure external enclosure gasket is undamaged and in place.
 Replace external enclosure lid and tighten screws to ensure dust-tight seal.
Gasket on screw