User's Manual

Page 3 of 10
Issuer: IWT, Inc. Doc. Num.: 6650-11-0040 Rev: A
Revised: Dec 15, 2011
Approval:
1. PRODUCT OVERVIEW
Innovative Wireless Technologies’ Sentinel Beacon is a transmitter intended primarily for use in
industrial mining applications. The FAP5015-050 Sentinel Beacon design provides enhanced
tracking for miners and equipment in high-traffic areas of a coal mine.
2. SAFETY INFORMATION
IMPORTANT INFORMATION ON SAFE OPERATION. READ THIS INFORMATION
BEFORE INSTALLING AND OPERATING THE SENTINEL BEACON.
2.1 Requirements for FCC Compliance
Changes or modifications to this unit not expressly approved by Innovative Wireless
Technologies (IWT) may void the user’s authority to operate this equipment.
FCC ID: SP8-FAP5015-050
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the
antenna used for this transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
The Sentinel Beacon must be installed 20cm or more from any personnel in order to comply with
FCC exposure requirements.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These designed limits provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no