Installation Manual

Page 13 of 15
Issuer: Cara Stephens Doc. Num.: 6640-08-0035 Rev: A
Revised: November 21, 2008
Approval:
DO NOT BLOCK VENT OPENING NEAR HANDLE OF ASSEMBLY ENCLOSURE>
DO NOT CHARGE BATTERY IN INVERTED POSITION.
AVOID EXPOSURE OF BATTERY ASSEMBLY TO HEAT. DO NOT PLACE IN CLOSE
PROXIMITY TO HEAT SOURCE WITHOUT PROPER VENTILATION.
6.2 INSTALLATIONS ABOVE GROUND (FMN / GWN)
At each of the sites determined by the survey described in 5.1:
6.2.1 Follow installation instructions of 6.1.
6.2.2 FMNs and GWNs installed above ground are not required to be part of a MSHA
approved system. MSHA-specific system restrictions on cable lengths, gauges, power
supplies, and backup battery may not apply.
6.2.3 Follow all FCC guidelines listed in Section 2.0.