User's Manual

Accutech reserves the right to substitute comparable components without notice.
CUT SHEET: Zone Receiver
The Zone Receiver is used to detect signals from an activated Tag. The Zone Receiver is always located near the monitored
zone. When the Controller is mounted at the zone, the Zone Receiver is housed in the Controller enclosure. When the
Controller is mounted away from the zone, the Zone Receiver is mounted externally in a 4”x4”x2” electrical box at the zone.
Zone Receivers monitor both zone events and Band Removal events while BR 4200 Auxiliary Receivers only monitor Band
Removal events.
ELECTRICAL:
Operating Voltage: 12V DC regulated
Cable: needs minimum 22-gauge, 12-conductor
MECHANICAL:
Size: If the Controller is located away from the zone,
the Receiver is mounted in a 4.00” x 4.00” x 2.00”
electrical box at the zone.
*Allow 7” depth for clearance of the BNC Rubber
Duck antenna
OPERATING CHARACTERISTICS:
Transmit Frequency: 418 MHz
Receive Frequency: 418 MHz
Frequency range: 40 feet radius (360º)
Jumpers settings:
JP1
(SS) Off
JP2 (Rx Test) Off
JP3 (Tag D) Off
JP4 (BR) On
JP5 (Reset) Off
ENVIRONMENTAL:
Operating Temperature: 32º to 120º Fahrenheit
Intended for indoor use only.
DUTY CYCLE:
Rated for continuous use.
Zone Receiver (Internal)
Model Number: ESRI
Part Number: 660076
UL Listed 294 (BP9480)
Access Control Accessory
Zone Receiver (External)
Model Number: ESRR
Part Number: 670076
800-356-2671 | Accutech | www.accutech-ics.com