User's Manual

Accutech reserves the right to substitute comparable components without notice.
CUT SHEET: Tx wand antenna
A Tx wand antenna located at a zone generates a Tag-activating radio frequency signal called the “Tx Activation Field.”
When a Tag is activated it sends a signal to the Receiver. The Receiver then sends the signal to the Controller, which
validates the signal before initiating any action such as locking a door, deactivating an elevator, or triggering system alarms.
Due to its ferrite bar, the Tx wand antenna must be mounted a minimum of 3 inches away from any metal. This includes door
frames, conduit, and lathe.
ELECTRICAL:
Operating Voltage: 30V AC (provided by Controller)
Wire Connections: Terminal Block
Cable: required minimum 18-gauge, 2-conductor,
shielded
MECHANICAL:
Construction: Vacuum molded ABS
Size: 13.25” x 2.50” x 2.25"
Weight: 1.5 US pounds
Mounting Surface: Four 3/16” screws
OPERATING CHARACTERISTICS:
Tuning Frequency: Nominal 131 kHz,
129-133 kHz for Stagger
Output Impedance: 300 ohms nominal
ENVIRONMENTAL:
Operating Temperature: 32º to 120º Fahrenheit
Intended for indoor use only.
DUTY CYCLE:
Rated for continuous use
.
Tx wand antenna (without cover)
Model Number: TW
Part Number: 700068
UL Listed 294 (BP9480)
Access Control Accessory
Tx wand antenna PCB
800-356-2671 | Accutech | www.accutech-ics.com