User's Manual

Accutech reserves the right to substitute comparable components without notice.
CUT SHEET: ES 2200 System Tags
ES 2200 System Tags are small wristwatch-sized devices worn by a resident or attached to an asset. When a resident or
patient enters a Tx Activation Field, the Tag sends a signal to the zone Controller via the Receiver. The zone Controller
processes this information for appropriate control action or response (e.g., sounding alarms, locking doors).
Available in LT (Long Term) or SB (Slotted Back) cases. LT Tags are used for resident care. SB Tags are used on small
infants and assets. “22” and “32” refer to the program running inside the Tag. The 22 program is meant strictly for ES
systems. The 32 program can be used in either ES or IS systems and displays a low battery condition.
ELECTRICAL:
ES 2200 System Tags operate by internal battery.
The Tags have been engineered for greater than 12
months usage and can be activated/deactivated with a
TAD.
MECHANICAL:
LT Size: 1¼” x 1½” x ½”
SB Size: 1½” x 1½” x ½”
LT/SB Weight (with band): 0.5 ounce
OPERATING CHARACTERISTICS:
Transmit Frequency: 418 MHZ
Receive Frequency: 128-133 kHz
ATTACHMENT:
ES 2200 System Tags are attached with a nylon-mesh-
reinforced vinyl band. The band is designed to resist
tearing caused by pulling or chewing on the band.
However, if the band becomes frayed or torn it will
need to be replaced. In long-term applications, the
band should be replaced periodically for cleanliness.
Tags are typically attached to a wrist or ankle.
MAINTENANCE:
 ES 2200 System Tags are reusable but they must
be thoroughly cleaned and sanitized between
applications.
Acceptable cleaning methods:
Antibacterial wipes or Hydrogen peroxide
(wipe, do not soak)
 ES 2200 Tag bands are for one-time use only.
 In long-term applications, periodically replace the
bands and clean the Tags.
TESTING:
There are 3 ways that you can test ES 2200 System
Tags:
 Enter a monitored zone (Alarm may sound)
 With a TAD
 With a PTAD
STORING:
Ideally, to preserve battery life and prevent nuisance
alarms, ES 2200 System Tags should be turned off
with a TAD, stored away from sources of electrical
noise, and stored in a metal container with lid. Extra
Tag bands should be stored in a clean and dry
environment.
Model Number: LTY Model Number SBY
Part Number: 77E018 Part Number 77EO16
UL Listed 294 (BP9480)
Access Control Accessory
VISUAL PULSE LED:
The Visual Pulse LED indicates the Tag’s current mode
LED Light Pattern
off on Tag LED Status
LT, SB Tags
None
Tag is off.
Active, not in zone
Active, in zone
BR, CB Tags
None
Tag is off.
Active, not in zone,
non-Band Alarm
Active, in zone
(may be in Band Alarm)
Active, not in zone
Band Alarm mode,
ENVIRONMENTAL:
Operating Temperature: 32º to 120º Fahrenheit
Intended for indoor use only.
800-356-2671 | Accutech | www.accutech-ics.com